Preh mc 15 Guía Del Usuario
14 3.2005
4. Driver Installation
Important Note:
A new calibration is always necessary if another touchscreen was connected to the
computer or if the screen resolution was changed. This means that the calibration between
touchscreen and computer is adjusted to the mechanical features of the particular
touchscreen which was connected to the computer at that time.
A serial Touch Controller is integrated into the Touch Commander. The default setting is
9600 Bps. Normally this is clearly recognized by the setup programs. If, however, it is not
clearly recognized, the adjustment can be done manually or by restarting the
corresponding setup program.
Information for the driver installation is in the file:
D:\MC15\TOUCH\TouchKit\...
computer or if the screen resolution was changed. This means that the calibration between
touchscreen and computer is adjusted to the mechanical features of the particular
touchscreen which was connected to the computer at that time.
A serial Touch Controller is integrated into the Touch Commander. The default setting is
9600 Bps. Normally this is clearly recognized by the setup programs. If, however, it is not
clearly recognized, the adjustment can be done manually or by restarting the
corresponding setup program.
Information for the driver installation is in the file:
D:\MC15\TOUCH\TouchKit\...
(MC15 T4, T5 or T6)
D:\MC15\TOUCH\ELO\
(MC15
T7)
You can find detailed information in the path, named with your operating system. (The CD-
ROM drive of your Tocuh-CD is here defined with the letter „D“).
ROM drive of your Tocuh-CD is here defined with the letter „D“).
4.1 Magnetic Card Reader Setup
The setup utility can be found on the installation CD at:
D:\MC15\MSR\PS2\MSR Utility Manual.pdf
(Drive D:\ shown above may vary on each system.)
D:\MC15\MSR\PS2\MSR Utility Manual.pdf
(Drive D:\ shown above may vary on each system.)