ONKYO dv-sp301 Manual De Instrucciónes

Descargar
Página de 40
9
Preparing the Remote Controller
1
Remove the battery compartment cover by pressing 
the tab and lifting up the cover.
2
Insert the two batteries (size AAA/R3).
Be sure to match the + and – ends of the batteries with the 
diagram inside the battery compartment.
3
Replace the battery compartment cover.
Notes
• Do not mix new batteries with old batteries or different kinds of 
batteries.
• To avoid corrosion, remove the batteries if the remote controller 
is not to be used for a long time.
• Remove dead batteries immediately to avoid damage from 
corrosion. If the remote controller does not operate smoothly, 
replace both batteries at the same time.
• The life of the batteries supplied is about six months but this will 
vary depending on usage.
Point the remote controller toward the remote control sensor.
Notes
• Place the unit away from strong light such as direct sunlight or 
inverted fluorescent light which can prevent proper operation of 
the remote controller.
• Using another remote controller of the same type in the same 
room or using the unit near equipment which uses infrared rays 
may cause operational interference.
• Do not put any object such as a book on the remote controller. 
The buttons of the remote controller may be pressed by mistake 
and drain the batteries.
• Make sure the audio rack doors do not have colored glass. 
Placing the unit behind such doors may prevent proper remote 
controller operation.
• If there is any obstacle between the remote controller and the 
remote control sensor, the remote controller will not operate.
Inserting the Batteries
Using the Remote Controller
Remote control sensor
A
pp
rox
. 1
fe
et
 (5
 m
)
30
°
30
°
00_DV-SP301.book  Page 9  Friday, April 18, 2003  4:18 PM