ONKYO DR-UN7 Manual De Instrucciónes

18

Read the following before connecting your speakers:
• You can connect speakers with an impedance of 

4 ohms or higher. If you use speakers with a lower 
impedance, and use the amplifier at high volume lev-
els for a long period of time, the built-in protection 
circuit may be activated.

• Disconnect the power cord from the wall outlet before 

making any connections.

• Read the instructions supplied with your speakers.
• Pay close attention to speaker wiring polarity. In other 

words, connect positive (+) terminals to only positive 
(+) terminals, and negative (–) terminals to only nega-
tive (–) terminals. If you get them the wrong way 
around, the sound will be out of phase and will sound 
unnatural.

• Unnecessarily long, or very thin speaker cables may 

affect the sound quality and should be avoided.

• Be careful not to short the 

positive and negative wires. 
Doing so may damage the AV 
receiver.

• Don’t connect more than one 

cable to each speaker termi-
nal. Doing so may damage 
the AV receiver.

• Don’t connect one speaker to several terminals.

The following illustration shows which speaker should 
be connected to each pair of terminals.

Strip 3/8" (10 mm) of insu-
lation from the ends of the 
speaker cables, and twist the 
bare wires tightly, as shown.

While pressing the lever, insert 
the wire into the hole, and then 
release the lever.
Make sure that the terminals are 
gripping the bare wires, not the 
insulation.

3/8" (10 mm)

Front right

speaker

Front left

speaker