Audiovox cs Manual De Propietario

E LE C T RO N I CS    C O R P.

E LE C T RO N I CS    C O R P.

2.   Source Select Control Button
      –  Press the source SELECT (S) button (2) to 

step through the different Audio/Video Input 
Sources, each press button of the SELECT 
(S) button (2) will advance to the next input 
source.  The source indicator LED (3) will light 
in the following sequences:

      –  Before attempting to operate the Remote 

Control, press and hold the source SELECT 
button (2) for 6 seconds until the source 
indicator LED (3) begins flashing.  Once the 
indicator is blinking the Control Station will 
accept Infrared input command signals from 
an Infrared Remote Control device.  To 
remove the Infrared Control function from the 
Control Station press and hold the button for 
3 seconds.                                                       
–  If source indicator LED (3) is blinking the 
S1 position, the Control Station has selected 
to control the Audio/Video Input at Source 1.  
To change the sources, press the source 
SELECT button (2) to view the following 
sources.

S1        S2        S3        S4

S1        S2        S3        S4

3.   Source Indicator LED
      – Indicates the video source that can will be 

viewed.

4.   Remote Sensor Eye
      – When the source indicator LED (3) is 

flashing, this indicates that the source 
equipment can be controlled remotely by 
pointing the remote control device at the 
remote device sensor.

5.   Volume Up/Down Button
      –  Press the “+” button to increase headphone 

volume.

      – Press the “–” button to decrease headphone 

volume.

6.   Headset (3.5mm Headphone jacks)
      –  These jacks provide connections for stereo 

headphones for private listening at each 
station. (Note: Plug the headphones in before 
putting the headphones on.  Adjust the 
volume to a low level before putting the 
headphones on.)

1. System Power Button   
      MAIN POWER (    ) button                                                               

–  Press to turn the Control Station on.  The 
LED indicators and 1 source LED indicator 
will illuminate.

      –  Press to turn the Control Station off.  The 

LED indicators will turn off and the MAIN 
POWER (    ) (1) will dimmed.

5

2

6

4

1

3

128-6055