Samsung CLP-610 Manual De Usuario

7.8   

<Troubleshooting>

Paper has jammed 
during duplex 
printing. This is 
applicable only to 
machines with this 
feature. 

Clear the jam. 
(Page 7.1)

There is a problem 
with the fan for the 
fuser unit.

Cycle power. If the 
problem persists, 
contact the service 
representatives.

The transfer belt is 
not installed.

Install a Samsung-
genuine transfer belt. 
(Page 8.1, Page 6.6)

The toner cartridge 
is installed 
improperly, or not 
installed.

Reinstall the toner 
cartridge two or three 
times to confirm it is 
seated properly. If the 
problem persists, the 
toner cartridge is not 
being detected. 
Contact the service 
representatives.

The toner cartridge 
which the arrow 
indicates is not 
suitable for your 
machine.

Install the 
corresponding toner 
cartridge with a 
Samsung-genuine 
cartridge. (Page 6.4)

The transfer belt is 
not suitable for your 
machine.

Reinstall the transfer 
belt two or three times 
to confirm it is seated 
properly. Make sure 
that the transfer belt 
is Samsung-genuine 
product. If the 
problem persists, 
contact the service 
representatives.

The network IP 
address you have 
set is being used by 
someone else.

Check the IP address 
and reset it if 
necessary. (Page 3.2)

The multi-purpose 
tray is empty in 
manual feed mode.

Load paper in the 
multi-purpose tray. 
(Page 4.6)

There is no 
corresponding paper 
in the corresponding 
tray.

Load corresponding 
paper in the 
corresponding tray. 
(Page 4.4)

The fuser unit is low-
heated.

Cycle power. If the 
problem persists, 
contact the service 
representatives.

There is a problem 
with the main motor 
for the machine.

Cycle power. If the 
problem persists, 
contact the service 
representatives.

Paper has jammed 
in the multi-purpose 
tray.

Clear the jam. 
(Page 7.3)

The problem has 
occurred in the 
newly installed fuser 
unit.

Cycle power. If the 
problem persists, 
contact the service 
representatives.

The toner cartridge 
which the arrow 
indicates is not a 
Samsung-genuine 
cartridge.

  Stop  

You can select either 
Stop or Continue 
with the left/right 
arrow.
If you select Stop by 
pressing OK on the 
control panel, the 
machine stops 
printing. If you select 
Continue, the 
machine keeps 
printing, but the 
quality cannot be 
guaranteed. 
If you do not select 
any, the machine will 
work as if Stop is 
selected. 
Replace the 
corresponding toner 
cartridge with a 
Samsung-genuine 
cartridge. (Page 6.4)

Paper has jammed 
in the paper feed 
area and inside the 
machine.

Clear the jam. 
(Page 7.1)

Paper has jammed 
inside the machine.

Clear the jam. 
(Page 7.1)

Special print media 
has jammed in the 
paper exit area.

Clear the jam. 
(Page 7.5)