Samsung CLX-6200 Guía Del Usuario

16 _Getting started

getting started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:
•

•

•

•

This section shows the steps to set up the hardware which is explained in 

the Quick Install Guide. Make sure you read Quick Install Guide and 

complete the following steps.
1. Select a stable location. 

Select a level, stable place with adequate space for air circulation. Allow 
extra space to open covers and trays. 

The area should be well-ventilated and away from direct sunlight or 

sources of heat, cold, and humidity. Do not set the machine close to the 
edge of your desk or table.

 

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the 

altitude setting to optimize your printing. Place the machine on a flat and 
stable surface, not letting it lean more than 2 mm (0.08 inches). 

Otherwise, it may affect the printing quality. 

2. Unpack the machine and check all the enclosed items.
3. Remove the tape holding the machine tightly.
4. Install all four of the toner cartridge.
5. Load paper. (See "Loading paper" on page 22.)
6. Make sure that all the cables are connected to the machine. 

7. Turn the machine on. 

Print a demo page to make sure that the machine is operating correctly.

To print a demo page:
In ready mode, press and hold the 

Cancel button for about 2 seconds.

Before you begin, ensure that your system meets the following 

requirements:

Your machine supports the following Windows operating systems.

When you move the machine, do not tilt or turn it upside down. 
Otherwise, the inside of the machine may be contaminated by toner, 

which can cause damage to the machine or bad print quality.

Pentium II 400 MHz 

(Pentium III 933 MHz)

64 MB 

(256 MB)

300 MB

Pentium III 933 MHz 

(Pentium IV 1 GHz)

128 MB 

(256 MB)

1GB

Pentium III 933 MHz 

(Pentium IV 1 GHz)

128 MB 

(512 MB)

1.25 GB to 

2 GB

Pentium IV 3 GHz

512 MB 

(1024 MB)

15 GB

•

Internet Explorer 5.0 or higher is the minimum requirement for all 

Windows operating systems.

•

Users who have an administrator right can install the software.