Polycom EX Guía De Referencia

Chapter 4 - Designing the User Experience

© Polycom, Inc.

4-23

You can enter or change the administrator and meeting passwords as well as 
specify whether to allow remote access to the system.

Go to System Info > Admin Setup > Security.

Configure these settings:

Admin Password

Enter or change the Admin Password. 

When the Admin Password is set, you must enter this password 
to:

Make configuration changes not in the User Settings screen

Update the software

Manage the system using the web interface

Meeting password

Specifies the password users must supply in the following 
instances:

Joining a multipoint call using the internal MCU

Viewing slides on the web interface

Viewing streams on the web interface

Accessing closed caption on the web interface

This field can also be used to store a password required by 
another system that this system calls. If a password is stored in 
this field, you do not need to enter it at the time of the call; your 
system supplies it to the system that requires it.

Software Update 
Password

Specifies the password required by the system to update the 
system software from another site over ISDN.

Call Encryption

(if enabled on the 
System Options 
screen)

Specifies whether to encrypt calls with other endpoints that 
support AES encryption.

Enable Remote 
Access

Specifies whether to allow remote access to the system by:

FTP

Web

Telnet

SNMP

You may select any of these, or any combination of them.

NOTE: The system reboots if you change the remote access 
settings.

Crypto Resync

Available if a V.35/RS-449/RS-530 network interface module is 
connected to the system.

For information about configuring crypto resync, please see