Polycom EX Guía Del Software
API Guide for ViewStation EX, ViewStation FX, and VS4000
244
www.polycom.com/videodocumentation
pricallbycall
Description
This command sets or gets the PRI area code. Call-by-call is a number from 1
to 31, which is optionally sent to an upstream telephone company switch, if
required. For example, specify a value of 6 for a T1 PRI network interface
module that is directly connected to an ATT 5ESS switch, which is
provisioned with Accunet. You must consult with the telephone company
service provider to determine whether a call-by-call value is required for a
particular PRI line. For most cases, the default value of 0 is correct. Always use
the value 0 when connected to a PBX. A non-zero value should not be
required in Europe. Values greater than 31 are reserved for internal use and
must not be used.
to 31, which is optionally sent to an upstream telephone company switch, if
required. For example, specify a value of 6 for a T1 PRI network interface
module that is directly connected to an ATT 5ESS switch, which is
provisioned with Accunet. You must consult with the telephone company
service provider to determine whether a call-by-call value is required for a
particular PRI line. For most cases, the default value of 0 is correct. Always use
the value 0 when connected to a PBX. A non-zero value should not be
required in Europe. Values greater than 31 are reserved for internal use and
must not be used.
Syntax
pricallbycall <set|get> [{0..31}]
Example
pricallbycall set 1
User Interface Screen Location
System Info > Admin Setup > Video Network > IMUX > PRI Network >
PRI Setup > Advanced PRI Setup: Call-by-Call
PRI Setup > Advanced PRI Setup: Call-by-Call
Note
This screen is only accessible if you have a PRI network interface
connected to your system.
connected to your system.
Parameter
Definition
set
Sets PRI call-by-call when followed by a value from
{0..31}.
{0..31}.
To erase the current setting, omit the value.
get
Returns the current setting.
{0..31}
Range of call-by-call values.