Polycom EX Guía Del Software

API Guide for ViewStation EX, ViewStation FX, and VS4000 

36

www.polycom.com/videodocumentation

camera far 2

This command causes the remote terminal to begin sending its camera 2.

move <direction> Changes the near or far camera’s direction or zoom. 

Valid directions are:

continuousSelects continuous movement mode. The 
camera will move in direction specified until a camera 
<near|far> move stop command is sent.

discreteSelects discrete movement mode. The 
camera will move a small amount in the direction 
specified and then stop. No stop command is 
required.

left

starts moving the camera to the left

right

starts moving the camera to the right

up

starts moving the camera up

down

starts moving the camera down

zoom- starts zooming out

zoom+ starts zooming in

stop

stops the camera motion in progress

Sets or gets the x, y, and z coordinates of the currently 
selected PTZ camera. 

Camera ptz range:

-880 <= x <= 880 (pan)

-300 <= y <= 300 (tilt)

0 <= z <= 1023 (zoom)

Note: Some D30 cameras might not be able to reach the 
designed range limit. For example, although the pan 
limit is 880, the camera might only be able to reach 860.

Stops the near or far camera when in continuous mode.

Tracking mode:

on

Turns on the far camera tracking mode. The 

far-site system must have the option Far Control of 
Near Camera enabled and auto tracking turned on.

off

Turns off the far camera tracking mode.

to_presetsTurns on the far camera tracking to presets.

get

Returns the far camera tracking mode.