Polycom vsx7000 Manual De Referencia
Integrator’s Reference Manual for the VSX Series
1 - 20
Configuring the Vortex, SoundStation VTX 1000, and VSX System to Work
Together
Together
1.
On the SoundStation VTX 1000:
a
Make sure the phone has software version 1.50.009 or later.
b
Select Menu > Admin Setup > Phone System > Vortex Mode to put
the SoundStation VTX 1000 in Vortex mode.
2.
Configure the Vortex to recognize the SoundStation VTX 1000
input/output, using Conference Composer™. Refer to Interfacing to the
SoundStation VTX 1000 with Vortex Devices, available at
www.polycom.com, for more information.
3.
Configure the Vortex to work correctly with the VSX system. Refer to the
Vortex/VSX 8000 Integration application note, available at
www.polycom.com, for more information.
4.
On the VSX system, go to System > Admin Settings > Audio > Next and
make these selections:
a
Set the audio input:
—VSX 8000: Set Input Type to Line Input.
—VSX 6000, VSX 7000, and VSX 7000e: Set Line Input to Audio
—VSX 8000: Set Input Type to Line Input.
—VSX 6000, VSX 7000, and VSX 7000e: Set Line Input to Audio
Mixer.
b
Disable Echo Canceller.
c
Disable the system microphones by deselecting Enable Polycom
Microphones.
5.
On the VSX system, go to System > Admin Settings > General Settings >
Serial Port and set the RS-232 Mode to Vortex Mixer. Verify that the
baud rate of the VSX system matches that of the Vortex.
6.
Make sure the VSX system input to the Vortex is assigned to the
appropriate AEC reference signal if the VSX system will be used in Mono
mode (Standard AEC Operation). If using Polycom InstantDesigner to
create the configuration settings for the Vortex, the reference will be set
automatically.