Boss Audio mr120 Manual De Usuario

Press this button to select Radio and CD modes.
The available selections depends on version:
Radio CD Player
Radio > CD > AUX in 

Sub-woofer On/Off 
Press SOURCE button for more than 3 seconds to activate or turn off the Sub-woofer output.

Press this button to remove the control panel.

Press this button to turn on or off the power.

Press this button briefly, the LCD will display the clock for about 2 seconds, then return to previous 
display mode.
Clock Adjustment
Under clock display mode, press DISP button until the LCD flashes, press Tuning Up Button to adjust 
hour and Tuning Down Button to adjust minute.

7

Initial installation of the unit when all wiring is completed.
All the function buttons do not operate.
Error symbol on the display.

Note: If the unit cannot function normally after reseting,  please use a cotton swab soaked in 
isopropyl alcohol to clean the socket on the back of the control panel.

The RESET button is located on the main unit (as shown on the diagram). To press it vertically with a 
ballpoint pen or metal object will activate it. The reset button is to be activated for the following reasons:

This unit features AUX IN line input jacks on both the front (headphone type) and rear (RCA 
type) panels.

PLEASE NOTE:
These two inputs cannot be used simultaneously. If 
you have a source unit plugged into the rear panel 
jack and wish to listen to a portable device (such as 
an MP3 player) by using the front panel jack, be sure 
to power off the unit plugged into the rear unit to 
avoid interference.
Similarly, if you have a device plugged into the front 
panel jack and wish to listen to the unit plugged into 
the rear panel, be sure to turn off the front panel 
device.
To select either the front or rear AUX IN device as a listening source, press the SOURCE 
button to select AUX mode. To cancel AUX IN listening, press SOURCE again.

3.5mm Audio In Cable (not included)

Right Audio

Left Audio

Ground

1

2

3