ICOM ic-207h Manual De Instrucciónes

5

REPEATER OPERATION

27

■ Offset frequency

➀

Push [BAND] to select the desired band.

➁

Select the mode/channel you wish to set the offset fre-
quency to, such as VFO mode or memory/call channel.

• The offset frequency can be independently programmed into

each mode or channel.

➂

Push [SET] one or more times until “DUP” appears and
flashes as shown above.

• Pushing [MONI] reverses the order of selection.
• Cancel the DTMF memory encoder in advance. (p. 48)

➃

Rotate the tuning dial to set the desired frequency.

• Selectable step increment is the same as the preset tuning step.

(p. 18)

• Use [V/MHz] for quick MHz setting.

➄

Push [V/MHz] to exit set mode.

The display shows that a 
0.6 MHz (600 kHz) fre-
quency is set.

Ä

Push [BAND] to select the desired band, if nec-
essary.

Å

Set the mode/channel you wish to set the off-
set frequency to, such as VFO mode or mem-
ory/call channel.

• The offset frequency can be independently pro-

grammed into each mode or channel.

Ç

Push [FSET] one or more times until “DUP” ap-
pears and flashes as shown at left.

• Pushing [GENT] reverses the order of selection.
• Cancel the DTMF memory encoder in advance.

(p. 48)

É

Push [Y] or [Z] to select and set the desired
frequency.

• Selectable step increment is the same as the preset

tuning step. (p. 18)

• Pushing and holding [Y] or [Z] changes the fre-

quency continuously.

Ñ

Push [ECLR] to exit set mode.

NOTE: The offset frequency can be set in a memory chan-
nel temporarily. However, the set contents are cleared
once the memory/call mode is selected. To store the offset
frequency permanently, overwrite the channel information.

SET

B