ICOM ic-2720h Manual De Instrucciónes
14
2
SETTING A FREQUENCY
New2001
2
■ Tuning step selection
[
Tuning steps are the minimum frequency change increments
when you rotate [DIAL] or push [Y]/[Z] on the microphone.
Independent tuning step for the left and right, as well as each
frequency bands can be set for individual tuning convenience.
The following tuning steps are available.
when you rotate [DIAL] or push [Y]/[Z] on the microphone.
Independent tuning step for the left and right, as well as each
frequency bands can be set for individual tuning convenience.
The following tuning steps are available.
• 5 kHz
• 10 kHz
• 12.5 kHz
• 15 kHz
• 20 kHz
• 25 kHz
• 30 kHz
• 50 kHz
☞NOTE: For convenience, select a tuning step that matches
the frequency intervals of repeaters in your area.
q Push the desired band’s [MAIN•BAND] to select the main
band.
• Push the same band’s [V/MHz•SCAN] to select VFO mode, if
necessary.
w Push [SET•
] to enter set mode.
e Push [SET•
] or [LOW•PRIO] several times until “tS” ap-
pears as shown below.
r Rotate the same band’s [DIAL] to select the desired tuning
step.
t Push [TONE•DTMF] to exit set mode.
z Push [BAND] to select the desired band (left or
right) as the main band.
• Push [VFO/LOCK] to VFO mode, if necessary.
x Push [
SET
B(D-OFF)] to enter set mode.
c Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] several
times until “tS” appears.
v Push [Y] or [Z] to select the desired tuning step.
b Push [
b Push [
CLR
A(MW)] to exit set mode.
SET
B
MAIN
T X
M
Push [SET• ]
[LOW•PRIO]
IC-2720H_2.qxd 03.5.13 9:45 Page 14 (1,1)