Furuno fi-3005 Manuales De Servicio
9
2.1
Location of the Server
The Server must be mounted on a dry, flat and vertical surface below deck , at least
500 mm (20") from radio receiving equipment.
Locate the Server in the centre of the boat and close to the electrical panel if possible.
500 mm (20") from radio receiving equipment.
Locate the Server in the centre of the boat and close to the electrical panel if possible.
2.2
Installing the Server
Remove the Server cover from the base plate by removing the two screws. Drill the 4
screw holes using a 2.8 mm (0.11") drill. Mount the Server using the 4 mounting
screws.
screw holes using a 2.8 mm (0.11") drill. Mount the Server using the 4 mounting
screws.
Apply silicon paste on the screw terminal. Connect the 8 m Nexus Network cable
labelled number 5 and supplied with cable protectors to the Server on pins 5, 6, 7, and
8. Match the colour codes for each wire.
labelled number 5 and supplied with cable protectors to the Server on pins 5, 6, 7, and
8. Match the colour codes for each wire.
Note: If the cable must be cut, it is recommended it is cut at the unmarked cable
end, since a marked cable is easier to identify.
end, since a marked cable is easier to identify.