Furuno MFD8 Guía Del Usuario
7. Fish Finder
7-2
7.2
How to Select a Display
Your fish finder has six display modes. These modes are single frequency, dual fre-
quency, marker zoom, bottom zoom, bottom lock, and A-scope.
quency, marker zoom, bottom zoom, bottom lock, and A-scope.
7.2.1
Single Frequency Display
The single frequency display shows either the low-frequency or high-frequency picture
on all the screen. Select a frequency according to your purpose.
on all the screen. Select a frequency according to your purpose.
• A low frequency gives a wide detection area. Use the low frequency for general
search and to find bottom conditions.
• A high frequency gives better resolution. Use the high frequency to inspect a school
of fish.
How to select a single-frequency display
Push the RotoKey to show the soft controls. Use
the RotoKey to select [LF (Low Frequency)] or
[HF (High Frequency)].
the RotoKey to select [LF (Low Frequency)] or
[HF (High Frequency)].
Note: For the FCV-1150, this function is inopera-
tive when the FCV-1150’s NavNet menu is set for
Gain/Mode. The message shown below appears.
Use the RotoKey to click the OK button.
tive when the FCV-1150’s NavNet menu is set for
Gain/Mode. The message shown below appears.
Use the RotoKey to click the OK button.
How to select the active TX frequency with the frequency selector icon
The frequency selector icon, at the top-left corner, switches between low and high fre-
quencies. Put the cursor on the icon then push the left-click button to switch between
high and low frequencies.
quencies. Put the cursor on the icon then push the left-click button to switch between
high and low frequencies.
Low
frequency
frequency
High
frequency
frequency
Detection Area
Frequency
selector icon
selector icon