Furuno MFD8 Guía Del Usuario
1. System Introduction
1-2
1.1.1
How to sleep the equipment
You can sleep the equipment when its use is not required continuously. With the Stan-
dard or Full RotoKey set active, push the RotoKey, rotate the key to select [Sleep]
then push the key. To un-sleep the equipment, push the power key until the picture
appears.
dard or Full RotoKey set active, push the RotoKey, rotate the key to select [Sleep]
then push the key. To un-sleep the equipment, push the power key until the picture
appears.
1.2
Controls
The controller for this system is either the MFD8 or MFD12.
A key that has two text labels separated by a line has two functions. The top label is
the main function and the bottom label, the secondary function. Short-push to access
the main function and long-push (approximately three seconds) to access the second-
ary function.
the main function and the bottom label, the secondary function. Short-push to access
the main function and long-push (approximately three seconds) to access the second-
ary function.
You operate the chart plotter, radar, fish finder, etc. with
• Keys
• CursorPad
• ScrollingPad
• RotoKey
• Menus, where you select options
• Pop-up menus, where you select options
• Lists, where you can edit items
When you operate a key, a single beep sounds to tell you correct operation. For wrong
operation, three beeps sound. If you do not need the key beep, deactivate the beep
sound from the [Global-General] menu.
• CursorPad
• ScrollingPad
• RotoKey
• Menus, where you select options
• Pop-up menus, where you select options
• Lists, where you can edit items
When you operate a key, a single beep sounds to tell you correct operation. For wrong
operation, three beeps sound. If you do not need the key beep, deactivate the beep
sound from the [Global-General] menu.