Furuno 511 Manuales De Servicio
i
CAUTION
In case of power failure turn off the
autopilot or manually steer the vessel.
autopilot or manually steer the vessel.
Leaving the equipment in the AUTO or
NAV mode during power failure will cause
wear on the rudder mechanism.
NAV mode during power failure will cause
wear on the rudder mechanism.
Use the correct fuse.
Use of a wrong fuse can cause fire or
damage the equipment.
damage the equipment.
SAFETY INSTRUCTIONS
Do not open the equipment
unless you are well familiar
with electrical circuits.
unless you are well familiar
with electrical circuits.
Only qualified personnel
should work inside the
equipment.
should work inside the
equipment.
WARNING
ELECTRICAL
SHOCK
HAZARD
Do not set the course changing speed
too high.
too high.
The boat will be turned too sharply at the
course change, which could create a very
dangerous situation.
course change, which could create a very
dangerous situation.
Do not use the autopilot in the
following situation:
following situation:
Harbor entrance or narrow channel
Where vessels change course often,
such as a cape or small island
Where vessels change course often,
such as a cape or small island
Observe the following cautions when
using the autopilot:
using the autopilot:
Maintain a vigilant watch
Watch for drifting of vessel
Watch for drifting of vessel
In an emergency, manually steer the
vessel.
vessel.
The autopilot cannot avoid vessels, etc.
automatically.
automatically.
Do not use the SIMULATION mode on
the boat.
the boat.
The rudder may move. This is special-
purpose mode for technicians.
purpose mode for technicians.
WARNING LABEL
A warning label is attached to the
processor unit. Do not remove the
label. If the label is missing or damaged,
contact your dealer about replacement.
A warning label is attached to the
processor unit. Do not remove the
label. If the label is missing or damaged,
contact your dealer about replacement.
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
remove cover. No user-serviceable
parts inside.
Name: Warning Label (1)
Type: 86-003-1011
Code No.: 100-236-231
Type: 86-003-1011
Code No.: 100-236-231
WARNING
Do not use the ORBIT mode in rough
sea.
sea.
Because the boat turns a 360-degree circle
around the waypoint a large wave or strong
wind can cause the boat to capsize.
around the waypoint a large wave or strong
wind can cause the boat to capsize.
For the figure eight mode, confirm that
no objection is in the general vicinity
of the waypoint.
no objection is in the general vicinity
of the waypoint.
The distance from the waypoint to the
turning point depends on boat's speed.
turning point depends on boat's speed.
Set the turn rate properly.
Setting the too high rate may cause sudden
turn.
turn.
When connecting a geomagnetism
detection type heading sensor, correct
magnetic field deviation.
detection type heading sensor, correct
magnetic field deviation.
If an autopilot is used without the compens-
ation, unexpected course change may occur.
ation, unexpected course change may occur.