Bunn HG Guía Del Usuario

BUNN Phase Brew is different from any brewer you’ve used before. Unlike ordinary coffee 

makers, BUNN Phase Brew doesn’t ‘drip’ right away. In fact, it doesn’t drip at all. That’s  

because BUNN Heat & Release Technology heats all the water to the right temperature, 

then quickly releases it through our unique sprayhead for an optimal 4-minute brewing 

phase and amazing coffee flavor in just 10 minutes!

 You must set the clock to use the brewer and the optional Auto-Start function. Remember to 

reset the clock for time changes and power outages.

Phase Brew Vs. TYPICaL DrIP

Plug 3-prong power cord into standard 

electrical outlet.

Display will flash until clock is set.

Press Clock button.

Set time using Hour and Minute buttons. 

Numbers scroll forward only. Take care 

to select correct AM/PM time.

Press Clock button again to lock in time.

Place BUNN coffee filter and coffee 

grounds into the brew funnel and slide into 

the funnel guides.

Fill brewer with 20 – 40 oz. of water and 

place carafe on base of brewer (failure to 

follow steps 1 and 2 may result in property 

damage).

Press Auto-Start button. Hour and Minute 

buttons will light up, time will flash on 

digital display.

Set time using Hour and Minute buttons. 

Numbers scroll forward only. Stop at 

desired Auto-Start time. Take care to 

select correct AM/PM time. 

When desired brewing time is on the 

digital display, it will be set and Auto-Start 

will activate in 10 seconds. Once activated, 

Auto-Start button will be illuminated.  Do 

not press the button again as it will cancel 

your selected Auto-Start time.

To check your Auto-Start setting at any 

time, press the Auto-Start button and the 

digital display will flash the programmed 

time. The flashing time will remain the set 

time unless you change it. After 10 seconds 

with no buttons pushed, the Auto-Start 

button will illuminate and Auto-Start is set.

The Auto-Start function must be  

activated each time you want to pre- 

schedule a brew. If the Auto-Start button 

is not illuminated, the Auto-Start  

function is not activated.

To cancel a programmed Auto-Start, press 

the Auto-Start button twice.