Bunn OT Guía Del Usuario

Page 25

FIG. 28 START SWITCH - MODEL RT

FIG. 27 START SWITCH - MODEL OT

FIG. 29 START SWITCH WIRING

Location:
The start switch is located in the base, below and to
the right of the brew station, FIG.s 27 & 28.

Test Procedure:
1.

Disconnect the brewer from the power source
and remove the wires from both terminals of the
start switch.

2.

Check for continuity across the two terminals on
the switch when it is held in the lower position.
Continuity must not be present across these ter-
minals in the upper position.

If continuity is present as described, reconnect the
wires, the switch is operating properly.
If continuity is not present as described, replace the
switch.

Removal and Replacement:
1.

Remove all wires from the switch terminals.

2.

Compress the clips inside the housing and gen-
tly push the switch through the opening.

3.

Push the new switch into the opening and spread
the clips to hold the switch captive in the hous-
ing.

4.

Refer to FIG. 29 when reconnecting the wires.

P1687

P1688

P1697

10021 071700