Bunn AXIOM-DV-APS Guía De Operación
Page 7
OPERATING CONTROLS
(A) ENABLE BREW ON/OFF SWITCH
Pressing the "ENABLE BREW ON/OFF" switch (indicator
on) supplies power to the brew station warmer, enables the
brew circuit, and energizes the tank refi ll circuit. Pressing the
switch again (indicator off) stops tank refi lling and brewing
and de-energizes the brew station warmer. Stopping a brew
cycle after it has been started will not stop the fl ow of water
into the server until the funnel is empty.
Pressing the "ENABLE BREW ON/OFF" switch (indicator
on) supplies power to the brew station warmer, enables the
brew circuit, and energizes the tank refi ll circuit. Pressing the
switch again (indicator off) stops tank refi lling and brewing
and de-energizes the brew station warmer. Stopping a brew
cycle after it has been started will not stop the fl ow of water
into the server until the funnel is empty.
NOTE – Hot water will be available at the faucet in a limited
amount when the "ENABLE BREW ON/OFF" switch is in
the "OFF" position because the tank will not refi ll.
amount when the "ENABLE BREW ON/OFF" switch is in
the "OFF" position because the tank will not refi ll.
(B) BREW SWITCH
Momentarily pressing and releasing the switch starts a brew cycle when the "ENABLE BREW
ON/OFF" indicator is on.
(C) ADDITIONAL WARMER SWITCHES
Pressing any additional warmer switch so that the indicator is on, supplies power to the associ-
ated warmer. NOTE: APS & TC models have no warmers.
P3633
39130 053107
COFFEE BREWING
1. Begin each brew cycle with a clean empty brew
1. Begin each brew cycle with a clean empty brew
funnel.
2. Insert a BUNN fi lter into the funnel.
3. Pour (or grind) fresh coffee into the fi lter and level
3. Pour (or grind) fresh coffee into the fi lter and level
the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails until it stops.
5. Place an empty server under the funnel.
6. Verify that the "ENABLE BREW ON/OFF" indicator
5. Place an empty server under the funnel.
6. Verify that the "ENABLE BREW ON/OFF" indicator
is on.
7. Momentarily press and release the "BREW" switch.
The display will read "NOW BREWING", and show
the time remaining in the brew cycle.
the time remaining in the brew cycle.
8. Following the brew, the display reads "DRIPPING"
which shows the time remaining until the coffee no
longer drips from the funnel tip.
longer drips from the funnel tip.
9. After the coffee fi nishes dripping from the funnel
tip, carefully remove the brew funnel and discard
the grounds and fi lter.
the grounds and fi lter.
B
A
C
NOTE: Some models are equipped with a backup
pour in feature, in case the plumbed water supply is
disrupted. In this event, disregard steps 7-8, and pour
in 64 ounces of fresh water.
pour in feature, in case the plumbed water supply is
disrupted. In this event, disregard steps 7-8, and pour
in 64 ounces of fresh water.