Bunn B10 Manual De Usuario

Descargar
Página de 12
6
PREPARING THE BREWER FOR USE
NOTE - THE BREWER IS NOT READY TO PLUG IN.
Do NOT plug in until Step #3.
  Raise the hinged flip-lid. 
  NOTE:  The  post  protruding  from  the  screen  is 
connected to a stopper that controls the flow of water 
into the tank. When lid is closed (post depressed), the 
stopper is raised and water will flow into the tank.
 
Plug in the brewer.
Step 2
  Slide an empty brew funnel into the brewer under 
the warmer switch. Pour one decanter full of water into 
the screened area on top of the brewer. Place decanter 
on the warmer. Close lid. Wait three minutes to allow 
the water to flow into the tank. Repeat this process. 
When the tank is full, some water will flow through the 
funnel and into the decanter.
P2240
P2247
P214
P219
Step 4
  Press  the  bottom  of  the  vacation  switch,  located  on 
the  lower  left  side  of  the  brewer,  to  the “ON”  (lower) 
position.
  The vacation switch controls power to the tank heater.
Initially you will have to wait approximately fifteen minutes 
in order for the water to reach brew temperature.
Empty any water that has collected in the decanter.  
The next page leads you through the five easy steps to  
‘BREWING DELICIOUS COFFEE’
Step 1
Step 3
B
U
N
N
6
4
8
10
OFF
O
N