Bunn HC-2 Manual De Usuario

25

Location:

The lamp starter (6) is located inside the door

assy (1) on the top of the door bottom cover (5).

Test Procedures:
1. Disconnect the dispenser from the power source.
2. Disconnect the plug on the starter leads from the

connector on the door wiring harness.

3. Remove lamp starter from starter socket.
4. Disconnect the two pin plugs of each of the starter

sockets from the door wiring harness.

5.  Check for continuity on each lead of the starter

socket.

If continuity is present as described the starter socket
is operating properly.
If continuity is not present as described replace the the
starter socket.

6. Remove starter (6) from starter socket.
7. Check for continuity across the pins on the bottom

of the starter (6).

If continuity is present as described , replace the
starter.
If continuity is not present as described, starter is
operating properly.

Note: If continuity test are both  as described and lamp
does not light, replace the starter socket.

Removal and Replacement (Refer to Fig.16):
1.

Open dispenser door assy (1)

2. Remove the six #8-32 screws securing the door

bottom cover (5) to the door assy (1).

3. Disconnect the plug on the starter socket and the

connector on the door wiring harness.

4. Remove cover (5) with starter w/socket (6) as

assembly.

5. Rotate starter 90

°

 and remove from the starter

socket.

6. Compress the spring tabs on the socket and re-

move socket from the door bottom cover (5).

7. Install new socket by compressing spring tabs on

the socket and pushing the socket up through the

hole in the bottom cover (5) and releasing spring
tabs.

8. Insert new starter (6) into socket and turn 90

°

 until

the pins snap in place.

9. Connect the plug on the sockets leads to the

connector on the door wiring harness.

10. Install door bottom cover (5) with starter and

starter socket  on door assy (1) using six #8-32
screws.

27591 031597