Bunn ICB-TWIN Guía De Operación

Page 14

 

This screen will be shown when the brewer is ready 

for use. The screen displays the water temperature 
in the tank. When the water in the tank reaches the 
correct set temperature, the display will change from 
HEATING to READY TO BREW.

This switch can be set to prevent access to the 

programming settings of the brewer. Once all the cor-
rect brew settings are programmed, the operator can 
set the switch to the "ON" position to prohibit anyone 
from changing the settings. With the switch in the 
"ON" position, the programming menus can still be 
accessed to view the current settings. However, no 
changes will be saved.

 

The programming of the brewer is divided into two levels. There is one function in Level 1. All other functions 

are accessed in Level 2.
 

 The following function screens are in order of appearance. Each screen will have instructions on how to 

access and the procedures for programming the various functions of the brewer.

 

To exit the programming mode at any time, press and release either ON/OFF pad located on the front switch 

panel. The display will return to the MAIN SCREEN.
 

If none of the fi ve programming switches are pressed within one minute during the setup of the brewer, 

the programming of the function screen that is being set will be exited and the display will return to the MAIN 
SCREEN.
 

Always remember to place a container and funnel under the sprayhead when operating the brewer during 

the set-up of CALIBRATE FLOW, and testing the brew and bypass valves in SERVICE TOOLS/TEST OUTPUTS.

P2426

38112.1 071206

READY TO BREW

WATER TEMP:  200°

MEMORY

  LOCK       UNLOCK

PROGRAMMING 

LOCKOUT SWITCH

P3048