Cma -66l Guía De Instalación Rápida
8
STEP
Adjust thermostat if necessary. Water temperature
should be 140
°F wash and 140°F rinse for CMA44L.
The CMA-44H should read 155
°F wash, 180°F rinse.
POWER
OFF-ON
OPERATING
INSTRUCTIONS
CMA-44 FRONT VIEW
1-2008
CMA-44/66
Quick Setup
Instructions
10
STEP
Turn on dishmachine by pressing the "POWER
ON/OFF"switch to the "ON"position. Dishmachine
will fill automatically and will also activate heater.
6
STEP
Close drain valve to allow machine to fill with
water.
9
STEP
CLOSE
POWER
ON/OFF
10
DETERGENT
PROBE INLET
6
SCRAP TRAP
DRAIN VALVE
9
PRESSURE
GAUGE
TEMPERATURE
GAUGE
Remove the stainless steel plug to install the detergent
probe (provided by dispensermanufacturer, CMA does
not supply).
7
STEP
Remove motor cap to verify motor rotation. Shaft slot
should be rotating clock-wise when motor is running. If
shaft slot is turning counter clock wise, swap L-1 and L-2
on main contactor.
THERMOSTAT
8
MOTOR CAP
7
THERMOSTAT
ACCESS
800-854-6417
WARNING
: Electrical and plumbing
connections need to be made by a
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
licensed service person and comply
with all Federal, State and Local
Health, Electrical, Plumbing and
Safety codes.
POWER
OFF-ON