Avaya 3910 Guía Del Usuario
Programming Mode
1.
Place the Programming Overlay over the dial pad of the system display phone
at extension 10 or 11—see “The Programming Overlays” earlier in this
chapter for more information.
at extension 10 or 11—see “The Programming Overlays” earlier in this
chapter for more information.
2.
To enter programming mode, press
Feature
0
0
.
The display reads:
PROGRAM EXT 10
If you are programming from extension 11, “11” displays instead of “10.”
3 .
Press
System Program
.
The display reads:
10 Enter name
This display is for the Extension Name Display feature. When you are
entering System Programming mode, skip it by moving on to Step 4.
entering System Programming mode, skip it by moving on to Step 4.
4.
Press
System Program
again. The display reads:
SYSTEM PROGRAM
5.
Specify a programming procedure in one of two ways:
■
Direct Method to dial the code for that procedure. System
Programming procedures in this guide are identified by # and a
three-digit code (for example, System Date is #101). This method is
best when you are using only a few procedures during a programming
session and you know the codes.
Programming procedures in this guide are identified by # and a
three-digit code (for example, System Date is #101). This method is
best when you are using only a few procedures during a programming
session and you know the codes.
■
Cycle Method to cycle through the procedures in numerical order.
Press
Next Procedure
and
Prev Procedure
to cycle forward and backward
through the programming procedures. This method is best when you
are using multiple procedures during a programming session, or if you
do not know the codes.
are using multiple procedures during a programming session, or if you
do not know the codes.
6.
To exit programming mode, you can press
Feature
0
0
or lift the handset
off-hook, then place it back in the cradle.
NOTE:
You can talk on the phone while you program. This is useful if you need to talk
with someone at the AT&T Helpline about programming. However, you must
with someone at the AT&T Helpline about programming. However, you must
call before you enter programming mode, and you must use the handset to talk,
not the speaker and microphone.
not the speaker and microphone.
Changing Programming Type
When you are in programming mode, you can move between System
Programming and Centralized Telephone Programming. To change to
Centralized Telephone Programming when you are in System Programming,
press
press
Central Tel Program
.
To move back to System Programming when you are
in Centralized Telephone Programming, press
Central Tel Program
then
System Program
.
2-14
Programming