Epson 7850p Hoja De Datos Del Producto
EPSON PowerLite 7850p Projector
6/03
EPSON PowerLite 7850p Projector
-
11
Setting the Remote Control ID
The remote control’s default ID is zero, which allows it to
control any projector (although not switch between
projectors). If you want to switch between projectors, follow
these steps to change the remote control’s ID to match that of
the projector:
control any projector (although not switch between
projectors). If you want to switch between projectors, follow
these steps to change the remote control’s ID to match that of
the projector:
1. Press the
ID
button on the remote
control. You see it light up.
2. Press one of the numbered
buttons on the remote
control to select the desired
ID (0 through 9). Select zero
to control all projectors, or
select a number to match the
ID of the projector(s) you
want to operate.
control to select the desired
ID (0 through 9). Select zero
to control all projectors, or
select a number to match the
ID of the projector(s) you
want to operate.
The
ID
button’s light shuts off and the new ID is registered.
If you would like to check the remote control’s current ID,
press the
press the
ID
button twice in succession. Count the number of
flashes; this number corresponds to the remote control’s ID. If
it doesn’t flash, the ID is set to zero.
it doesn’t flash, the ID is set to zero.
Presenting Over a Wireless Network
Using EMP NS Connection, you can project images shown
on your computer screen directly to your audience without
connecting the projector to your computer. Before you begin,
make sure you’ve installed EMP NS Connection from the
CD-ROM that came with your projector. See the User’s Guide
for installation instructions.
on your computer screen directly to your audience without
connecting the projector to your computer. Before you begin,
make sure you’ve installed EMP NS Connection from the
CD-ROM that came with your projector. See the User’s Guide
for installation instructions.
Note: Your computer must be running Microsoft
®
Windows XP,
2000, Me or 98. EMP NS Connection does not support
Macitnosh.
Macitnosh.
Starting EasyMP
Before you can connect to the projector wirelessly, you have to
switch it to EasyMP mode.
switch it to EasyMP mode.
1. Turn on the remote control and the projector. Press the
EasyMP
button on the remote control to select EasyMP as
the source.
2. Locate the EPSON 802.11b card that came with your
projector. Insert it with the blue label facing outward.
Note: Only the EPSON 802.11b card is guaranteed to work.
Other cards may not be compatible.
Other cards may not be compatible.
Depending on whether your projector is set up to
connect in Ad Hoc mode or Access Point mode (also called
infrastructure mode), you see one of these screens:
connect in Ad Hoc mode or Access Point mode (also called
infrastructure mode), you see one of these screens:
If you’ve already configured the projector for your wireless
network, go to “Projecting Wirelessly” on page 15. Otherwise,
continue with the next section.
network, go to “Projecting Wirelessly” on page 15. Otherwise,
continue with the next section.
Zero
Ad Hoc mode
Access Point
mode
mode