Hitachi 802.11b/g/n USB USBWL11N Manual De Usuario

62

You can configure and control the projector via the network using RS-232C 

commands.

Communication Port
The following two ports are assigned for the command control.

Command Control Settings (&22)

4)  Click the 

[Enable] check box to open Network Control Port1 (Port: 23) to use 

TCP #23. Click the 

[Enable] check box for the [Authentication] setting when 

authentication is required, otherwise clear the check box.

5)  Click the 

[Enable] check box to open Network Control Port2 (Port: 9715) to 

use TCP #9715. Click the 

[Enable] check box for the [Authentication] setting 

when authentication is required, otherwise clear the check box.

6) Click the 

[Apply] button to save the settings.

Configure the following items from a web browser when command control is used.
Example: If the IP address of the projector is set to 192.168.1.10:

1)  Enter 

“http://192.168.1.10/” into the address bar of the web browser, and 

select Projector Web Control from the selection window.

2)  Enter your user name and password, and then click the 

[OK]. 

3) Click the 

[Port Settings] on the main menu.

TCP #23 

TCP #9715 

• Command control is available only via the specified port above.