Gateway 400SD4 Guía De Referencia
Regulatory compliance statements
117
Caution
Wireless devices are
not user-serviceable.
Do not modify them in
any way. Modification
to a wireless device will
void the authorization
void the authorization
to use it. Contact
Gateway for service.
Caution
The transmitting
device embedded in
this notebook may not
be used with any
antenna other than
provide with the
notebook.
Caution
The 802.11A radio LAN
your notebook may
have been equipped
with operates in the
same frequency range
as high power radar,
which has priority use,
and may damage the
radio LAN if both are
present and being
used in the same area.
As a general guideline, a separation of 8 inches
(20 cm) between the wireless device and the
body, for use of a wireless device near the body
(this does not include extremities) is typical. This
device should be used more than 8 inches
(20 cm) from the body when wireless devices are
on. The power output of the wireless device (or
devices), which may be embedded in your
notebook, is well below the RF exposure limits as
set by Industry Canada.
(20 cm) between the wireless device and the
body, for use of a wireless device near the body
(this does not include extremities) is typical. This
device should be used more than 8 inches
(20 cm) from the body when wireless devices are
on. The power output of the wireless device (or
devices), which may be embedded in your
notebook, is well below the RF exposure limits as
set by Industry Canada.
Operation of this device is subject to the
following two conditions: (1) This device may not
cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation
of the device.
following two conditions: (1) This device may not
cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired operation
of the device.
Unintentional emitter per ICES-003
This digital apparatus does not exceed the
Class B limits for radio noise emissions from
digital apparatus as set out in the radio
interference regulations of Industry Canada.
Class B limits for radio noise emissions from
digital apparatus as set out in the radio
interference regulations of Industry Canada.
Le présent appareil numérique n’émet pas de
bruits radioélectriques dépassant les limites
applicables aux appareils numériques de
Classe B prescrites dans le règlement sur le
brouillage radioélectrique édicté par Industrie
Canada.
bruits radioélectriques dépassant les limites
applicables aux appareils numériques de
Classe B prescrites dans le règlement sur le
brouillage radioélectrique édicté par Industrie
Canada.
Telecommunications per Industry Canada CS-03
(for products fitted with an IC-compliant modem)
(for products fitted with an IC-compliant modem)
The Industry Canada label identifies certified
equipment. This certification means that the
equipment meets certain telecommunications
network protective, operation, and safety
requirements. The Department does not
guarantee the equipment will operate to the
users’ satisfaction.
equipment. This certification means that the
equipment meets certain telecommunications
network protective, operation, and safety
requirements. The Department does not
guarantee the equipment will operate to the
users’ satisfaction.
Before installing this equipment, users should
make sure that it is permissible to be connected
to the facilities of the local telecommunications
company. The equipment must also be installed
using an acceptable method of connection. In
some cases, the inside wiring associated with a
make sure that it is permissible to be connected
to the facilities of the local telecommunications
company. The equipment must also be installed
using an acceptable method of connection. In
some cases, the inside wiring associated with a