Gateway 2500 Guía Del Usuario
46 Using Your Gateway Solo 2500 Multimedia Notebook
1.
Make sure the power is turned off, AC disconnected, and battery is
removed.
removed.
2.
Press into the bay tracks and slide the HDD firmly into the bay.
3.
Secure the HDD with the screw.
4.
Turn the notebook over and reconnect the AC adapter and replace the
battery pack. See “Connecting the AC power” on Page 18.
battery pack. See “Connecting the AC power” on Page 18.
5.
Start up the system when you are ready to use it.
6.
If this is a first time installation, then follow the information that
accompanied the HDD to prepare it for use.
accompanied the HDD to prepare it for use.
Using PC Cards
Your notebook’s PC Card slots (also known as PCMCIA card slots) are
located behind the PC Card doors on the right side of your notebook (see
“PC Card slots” on Page 11). These slots accept PC Card 16, PC Card 32
(CardBus) or Zoomed Video cards.
located behind the PC Card doors on the right side of your notebook (see
“PC Card slots” on Page 11). These slots accept PC Card 16, PC Card 32
(CardBus) or Zoomed Video cards.
Your notebook is configured to automatically accept most PC Cards. If you
ordered your notebook with a modem, then the modem drivers are already
installed.
ordered your notebook with a modem, then the modem drivers are already
installed.
You do not need to restart your notebook when changing most cards
because your notebook supports “hot-swapping.” This means that you can
usually insert a PC Card and the system recognizes it without shutting down
the notebook. If your PC Card does not work when hot-swapping, refer to
the PC Card manufacturer’s documentation for further information.
because your notebook supports “hot-swapping.” This means that you can
usually insert a PC Card and the system recognizes it without shutting down
the notebook. If your PC Card does not work when hot-swapping, refer to
the PC Card manufacturer’s documentation for further information.
To replace the hard disk drive