Sony fwd-50px3 Guía De Operación

 GB

“H/Comp”: Select when a horizontal signal or a composite synchronous signal 
is input.
“Video”: Select when a video signal is input.

• “Sync Mode” is not available for PC input.
• Depending on the level of the composite synchronous signal, the image may not be displayed 

correctly. In this case, change the “Sync Mode” setting.

• There are some inputs for which only synchronizing signals can be selected. In this case, 

input horizontal/vertical synchronization signals through the pin 13 or 14 of the connectors.

• Sync Mode settings cannot be carried out for the input through the optional adaptors.
• This display does not support the three value sync format of composite sync and 576/60p.
• When you select the video signal for the synchronous mode setting, you cannot use the PAP 

function.

“Display”/“Option1”/“Option2”: Sets the type of signal for a video equipment 
or PC connected to the HD15 IN (RGB/COMPONENT) connector of the display 
or the optional adaptors.

“Auto”: Select to choose either an analog RGB input signal or a component 
input signal from a connected equipment.
“RGB”: Select to choose an analog RGB input signal from a connected 
equipment.
“YUV”: Select to choose a component input signal from a connected 
equipment.

For the available combination of two pictures, see page 24.

“Color System”: Select the color system of video signals from “Auto”, “NTSC”, 
“NTSC4.43”, “PAL”, “PAL-M”, “PAL-N” or “PAL60”. Select “Auto” to set the 
color system automatically.

“Color System” is not available for PC input.
“Network Port”: Sets the network port to operate the display by remote control.

“Off”: Select when not using the network port. The power consumption during 
standby mode can be reduced.
“Display”: Allows you to make settings of the display from a PC connected to 
the REMOTE (LAN) connector of the display. (page 34)
“Option1”: Allows you to make settings of the display from a PC connected to 
the REMOTE connector or the LAN connector of the OPTION 1 slot. (page 34)

“IP Address Setup”: Sets an IP address to enable communication speed between 
the REMOTE (LAN) connector of the display or the optional adaptor and the 
equipment such as a PC connected with the LAN cable. 
“Speed Setup”: Sets a communication speed between the REMOTE (LAN) 
connector of the display or the optional adaptor and the equipment such as a PC 
connected with the LAN cable.

For details on how to make the settings of “IP Address Setup” and “Speed Setup”, see the 
section of “Preparations for Using the Network Functions” (page 32).

Displays the “Model Name”, “Serial Number”, “Operation Time”, “Software 
Version” and “IP Address” of your display.

Resets all adjustments and settings to factory settings.

The items included in the “Information” option and the “Index Number” will not be 
reset.