Sony klv-s19a10 Guía De Operación
Connecting the TV
30
KLV-S19A10/KLV-S23A10/KLV-S26A10/KLV-S32A10
2-589-826-13(1)
G:\SONY\03 TV\834494S KLV-S19-
32A10_EN\0601_EN\2589826131\2589826131 KLVS19-
32A10_US\01US04INS.fm
32A10_EN\0601_EN\2589826131\2589826131 KLVS19-
32A10_US\01US04INS.fm
masterpage:3 columns Right
Setting Up the Channel List
After you finish connecting your TV, you need to run Initial Setup, which
automatically sets up available channels. The Initial Setup screen appears
when you turn on your TV for the first time after hooking it up. If you do not
want to set up the channels at this time, you can do it later by selecting the
automatically sets up available channels. The Initial Setup screen appears
when you turn on your TV for the first time after hooking it up. If you do not
want to set up the channels at this time, you can do it later by selecting the
Auto Program
option in the
Channel
settings (see page 53).
Using Initial Setup
To run Initial Setup the first time you turn on your TV
1
Press
POWER
to turn on the TV.
The Initial Setup screen appears.
2
Press
V or v to select the on-screen display language. Then press
.
The message “First please connect cable/antenna” appears.
3
Press
CH +
to start Auto Program.
Auto Program automatically creates a list of receivable channels. When
finished, the lowest numbered channel is displayed. When all the receivable
channels are stored, the
finished, the lowest numbered channel is displayed. When all the receivable
channels are stored, the
Show/Hide Channels
settings appear.
To scan available VHF/UHF antenna channels instead of the cable TV
channels
channels
1
Select
Settings
in
WEGA GATE
, then go to
Channel
settings.
2
Set
Cable
to
Off
.
3
Start Auto Program by pressing
CH +
.
To perform Auto Program again, follow the above instructions.
Depending on your signal source, be sure to set
Depending on your signal source, be sure to set
Cable
to
On
or
Off
accordingly (see page 53).
The Auto Program feature does not apply for installations that use a
cable box.
cable box.
The factory default setting for channel selection is Cable On. For
antenna connections, run the Auto Program again after selecting Cable
Off from the settings.
Off from the settings.
By default, Auto Program is set to scan cable TV channels.
The Initial Setup menu will appear each time the TV is turned on until
you complete the scanning for the available channels.
you complete the scanning for the available channels.
01US02WAR-UC.book Page 30 Wednesday, June 1, 2005 4:07 PM