Speco cvc-927ptz Manual De Usuario

 

5. After aiming the camera (view direction and lens control), release CTRL/PGM. Then twist the 

 handle or Press Tele or Wide Key to store the selected view. The position number 

will be displayed and the user will be prompted to enter a preset title. 

6. Enter the title for the preset position using the Joystick. (Rotate handle clockwise and 

counterclockwise or press Tele or Wide Key to scroll through the alphanumeric characters, 
push the handle to right or left to select next or previous digit.) 

7. When you are finished entering the title, push the Joystick downward. Set the focus by 

pushing the Joystick to the right or left.  Set the IRIS value in the same manner as the focus. 

8. Move to the DWELL setting by pushing the Joystick down. Twist the Joystick clockwise or 

counterclockwise to increase or decrease dwell time of the preset position. 

9. To select the next page of presets, scroll the page by pushing the Joystick to the Left on the 

first and last columns of the menu. 

10. Repeat steps 2 through 7 for each additional preset position. 
11. To edit the title of a stored preset, use the Joystick to position the cursor on the desired 

preset position. Press the Prst key to recall the stored preset. Twist the zoom handle 
clockwise to enter the preset title, focus and IRIS. Preset titles are useful with short cut 
preset programming. Refer to Shortcut programming below. 

12. Select Save and Exit by pushing the Joystick to the right. Press ESC to exit the Preset menu 

without saving. 

 

 
 

 
Select a view to be stored (direction of the camera, zoom and focus), then press No. (1 to 240), 
and then press PGM, PRST subsequently. The current view will be stored to the selected preset 
number if position is empty. If selected preset number is not empty, “PRESET EXISTING” 
message will be displayed on the monitor and be prompted to overwrite.  
 
Example

: 1 , 0 , 1  + PGM + PRST will store current view as preset No. 101. In this case, focus 

and Iris mode will be programmed as Auto, dwell time will be set to 3 sec.  
 

3.7 Tour 

(THIRD ITEM OF THE MAIN MENU / SHORTCUT: 

)

 
There are 8 programmable Tours. Each Tour consists of up to 42 Preset positions, Patterns, 
Scans or other Tours (second-level). Using second-level Tours, it can be expanded to over 300 
functions in a single Tour. However second level Tours will be ignored when called by a Tours. 
The following example illustrates this concept: 
 
If 

  Tour1 has Preset1ÎPreset2ÎTour2ÎTour3 and 

Tour2 has Preset3ÎPreset4ÎTour4ÎPreset5 and 
Tour3 has Preset6ÎPattern 1and 
Tour4 has Preset7. 

 

Tour1 executes as follows: 
Preset1 Î Preset2 Î Preset3 Î Preset4 Î Preset5 Î Preset6 Î Pattern1 Î  
Preset1 Î ... (Repeat) 
 

 15