KYOCERA ep c170n Guía Del Usuario
Using the Operator Panel
ADVANCED OPERATION GUIDE
2-53
Writing Data
Data can be written to a memory card until the card is full. When writing to
a memory card, a name is assigned to the file automatically. You can use
the procedure explained in the section Printing a List of Data Names
(Partitions) on page 2-56 to print a list of data names for confirmation.
a memory card, a name is assigned to the file automatically. You can use
the procedure explained in the section Printing a List of Data Names
(Partitions) on page 2-56 to print a list of data names for confirmation.
NOTE:
First check that the memory card is properly formatted.
Otherwise, the >Write Data message to be explained below will not be
shown on the message display. If the memory card inserted in the
memory card slot is not formatted, >Format will automatically appear on
the message display. Format the memory card. See Formatting a Memory
Card on page 2-55.
shown on the message display. If the memory card inserted in the
memory card slot is not formatted, >Format will automatically appear on
the message display. Format the memory card. See Formatting a Memory
Card on page 2-55.
1
Press [MENU].
2
Press
U or V repeatedly until Memory
Card
> appears.
3
Press
Z.
4
Press
U or V repeatedly until >Write
Data
appears.
5
Press [OK] ([ENTER]). A question mark (?)
appears.
appears.
6
Press [OK] ([ENTER]). Processing appears, then Waiting.
7
Send the file from the computer to the printer.
As the printer receives data, the message display changes to
Processing
Processing
, then when the end of the data is received, the message
display changes to Waiting.
8
Check that the message display has changed to Waiting, then press [GO].
This writes the file to the memory card and instructs the printer to
automatically print out a memory card write information page as shown
below.
This writes the file to the memory card and instructs the printer to
automatically print out a memory card write information page as shown
below.
The file is written onto the memory card given a destination name (also
referred to as a partition name) which the printer automatically assigns one
referred to as a partition name) which the printer automatically assigns one
Memory Card >
>Write Data
>Write Data ?