KYOCERA KM-8530 Guía De Referencia
Using
11
Changing the User Mode
Note: The default User Mode for Job Spooler is Per User.
The User Mode may be set to Per User or All User. To set the User Mode to either of
these options, follow this procedure:
these options, follow this procedure:
1. Open the Job Spooler page.
2. There are four buttons just below the Network Card Serial Number. These are
called the Main Menu buttons. Click the Setup button, the last button on the right
side. The Setup page opens (Figure 3.2).
3. Two Setup Sub-buttons have been added to the menu. Click the Set User
Mode button. The User Mode screen opens (Figure 3.3).
4 The Current User Mode is displayed. Should you wish to change this mode,
enter the system password.
Note: The default system password is sysadm. Instructions for changing
the password may be found in Section Four of the Web Utilities User's
Reference Guide.
the password may be found in Section Four of the Web Utilities User's
Reference Guide.
5. Click Accept. If the Mode has been changed, a new screen will open, informing
you that the change was accepted (Figure 3.4).
6. Click the Job Spooler function button to return to Job Spooler.