Viewsonic SD-A245 Guía De Instalación Rápida

i

• Use only the batteries and power adapter provided by the manufacturer. The use of unauthorized accessories 

may void your warranty.

• Do not store your device in temperatures higher than 50°C (122°F).

• The operating temperature for this device is from 0°C (32°F) to 35°C (95°F).

The following statement applies to all products that have received FCC approval. Applicable products bear the 

FCC logo, and/or an FCC ID in the format FCC ID: GSS-VS15197 on the product label.This device complies with 

part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause 

harmful interference, and (2) This device must accept any interference received, including interference that may 

cause undesired operation. This mobiledevice has been tested and found to comply with the limits for a Class B 

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can radiate radio 

frequencyenergy and, if not installed and used in accordance with the instructions, may cause harmful interferenceto 

radio communications. However, there is no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following 

measures

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void theuser’s 

authority to operate the equipment.The antenna(s) used for this transmitter must not be colocated or operating in 

conjunction with any otherantenna or transmitter.

The device was tested and complies to measurement standards and procedures specified in FCC OET Bulletin 65, 

Supplement C

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users 

must follow the specific operating instructions for satisfying RF exposure compliance. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This 

equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and 

your body.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following 

two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, 

including interference that may cause undesired operation of the device. 

To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 20 cm must be 

maintained between the antenna of this device and all persons.

Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de séparation d'au moins 20 

cm doit être maintenue entre l'antenne de cet appareil et toutes les personnes.

The device complies with the EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC, R&TTE 

Directive 1999/5/EC.