Viewsonic PJD7830HDL Manual De Usuario
41
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not
turned on). To use these functions, be sure you have turned on the corresponding
menus under SOURCE > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the
turned on). To use these functions, be sure you have turned on the corresponding
menus under SOURCE > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the
chapter.
Active VGA out
Selecting On outputs a VGA signal when the COMPUTER IN and COMPUTER OUT
sockets are correctly connected to devices. The projector outputs the signal received
only from COMPUTER IN.
sockets are correctly connected to devices. The projector outputs the signal received
only from COMPUTER IN.
Active Audio out
Selecting On outputs an audio signal when the AUDIO IN 1 socket is correctly
connected to a proper device.
connected to a proper device.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker.
Be sure you have made a correct connection to the projector audio input/output jacks.
See
Be sure you have made a correct connection to the projector audio input/output jacks.
See
for more details.
Adjusting the audio mode
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Audio Mode menu.
2. Press
/
to select a preferred audio mode.
• If available, you can press Audio Mode on the remote control to select a preferred audio
mode.
Muting the sound
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Mute menu.
2. Press
/
to select On.
• If available, you can press
on the remote control to toggle the projector audio between on
and off.
Adjusting the sound level
1. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Audio
Settings > Audio Volume menu.
2. Press
/
to select a desired sound level.
• If available, you can press
/
on the remote control to adjust the projector’s sound
level.