Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Viewsonic
  4. PJD6350
  5. Manual De Usuario

Viewsonic PJD6350 Manual De Usuario

Descargar
Página de 95
39
Controlling the projector through a LAN 
environment
The projector supports Crestron
®
 software. With correct settings for the LAN Control 
Settings menu, you can manage the projector from a computer using a web browser when 
the computer and the projector are properly connected to the same local area network. 
Configuring the LAN Control Settings
If you are in a DHCP environment:
1.
Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector 
and the other end to the RJ45 port.
2.
Open the OSD menu and go to the SOURCE >  LAN Control Settings menu.
3.
Press Enter. The LAN Control Settings page is displayed.
4.
Highlight LAN Control Settings and press 
/  to select DHCP ON.
5.
Press 
 to highlight Apply and press Enter.
6.
Please wait for around 15 - 20 seconds, and then re-enter the LAN Control Settings 
page. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server 
settings will be displayed. Note down the IP address displayed in the Projector IP 
Address row.
If the Projector IP Address still does not appear, contact your network administrator.
If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, Default 
Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are properly 
connected and perform the procedures above again.
If you need to connect to the projector in its standby mode, set LAN Control to On in the 
SOURCE > Standby Settings menu.
If you are in a non-DHCP environment:
1.
2.
Highlight LAN Control Settings and press 
/  to select Static IP.
3.
Contact your ITS administrator for information on the Projector IP Address, Subnet 
Mask, Default Gateway, and DNS Server settings.
4.
Press 
 to select the item you want to modify and press Enter.
5.
Press 
/  to move the cursor and the press
 
/
 
to enter the value.
6.
To save the settings, press Enter. If you do not want to save the settings, press Exit.
7.
Press 
 to highlight Apply and press Enter.
(An example of connection)