Viewsonic PJD6350 Manual De Usuario

63

There is no power from the power cord.

Plug the power cord into the AC inlet on the 
projector, and plug the power cord into the power 
outlet. If the power outlet has a switch, make sure 
that it is switched on.

Attempting to turn the projector on again 
during the cooling process.

Wait until the cooling down process has completed.

The video source is not turned on or 
connected correctly.

Turn the video source on and check that the signal 
cable is connected correctly.

The projector is not correctly connected to 
the input signal device.

Check the connection.

The input signal has not been correctly 
selected.

Select the correct input signal with the Source key 
on the projector or remote control.

The projection lens is not correctly focused. Adjust the focus of the lens using the focus ring.
The projector and the screen are not 
aligned properly.

Adjust the projection angle and direction as well as 
the height of the projector if necessary.

The battery is out of power.

Replace the battery with a new one.

There is an obstacle between the remote 
control and the projector.

Remove the obstacle.

You are too far away from the projector.

Stand within 8 meters (26 feet) from the projector.

The remote control code on the projector 
and the remote contorl is not consistent.

Adjust the remote control code.