Viewsonic PJD5151 Manual De Usuario
47
Using the dust filter
(optional accessory)
CAUTION
•
It is important to clean the dust filter every 100 hours after the dust filter is installed.
•
Be sure to turn off the projector and unplug it from power source before installing or
detaching the filter.
detaching the filter.
•
If your projector is ceiling-mounted or is not easily accessible, pay special attention to
your personal safety when replacing the dust filter.
your personal safety when replacing the dust filter.
Installing the dust filter
1.
Be sure to turn off the projector and unplug
it from power source.
it from power source.
2.
As the arrows shown to the right, fit the filter
by aligning and inserting it into the projector
slots. Make sure it clicks into place.
by aligning and inserting it into the projector
slots. Make sure it clicks into place.
For first time installation:
3.
3.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Filter
Settings menu.
Settings menu.
4.
Press Enter and the Filter Settings page is displayed.
5.
Highlight Filter Mode and press
/ to select On. The filter timer starts counting
and the projector will remind you to clean the filter when the filter is in use for over
100 hours.
100 hours.
Set Filter Mode to On only when using the projector after the dust filer (optional accessory) is
properly attached. Failing to do so will result in a shorter lamp life.
properly attached. Failing to do so will result in a shorter lamp life.
Obtaining the filter hour information
1.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Filter Settings menu.
Filter Settings menu.
2.
Press Enter. The Filter Settings page is displayed.
3.
You will see the Filter Hours information on the menu.
Cleaning the dust filter
1.
Be sure to turn off the projector and unplug it from power source.
2.
Press the latches on the dust filter and remove the filter from the projector.
3.
Use a small vacuum cleaner or a soft brush to sweep the dust on the filter away.
4.
Re-install the dust filter.
Resetting the filter timer
5.
5.
Open the OSD menu and go to the SYSTEM SETTING: ADVANCED >
Filter Settings menu.
Filter Settings menu.
6.
Press Enter and the Filter Settings page is displayed.
7.
Highlight Reset Filter Hours and press Enter. A warning message is displayed
asking if you want to reset the filter timer.
asking if you want to reset the filter timer.