Sony DSX-A400BT Manual

Descargar
Página de 108
3
GB
This device complies with Part 15 of the FCC Rules 
and Industry Canada's licence-exempt RSSs. 
Operation is subject to the following two 
conditions: 
(1) This device may not cause interference; and 
(2) This device must accept any interference, 
including interference that may cause undesired 
operation of the device.
This transmitter must not be co-located or operated 
in conjunction with any other antenna or 
transmitter.
Under Industry Canada regulations, this radio 
transmitter may only operate using an antenna of a 
type and maximum (or lesser) gain approved for 
the transmitter by Industry Canada. To reduce 
potential radio interference to other users, the 
antenna type and its gain should be so chosen that 
the equivalent isotropically radiated power (e.i.r.p.) 
is not more than that necessary for successful 
communication.
This equipment complies with FCC/IC radiation 
exposure limits set forth for an uncontrolled 
environment and meets the FCC radio frequency 
(RF) Exposure Guidelines and RSS-102 of the IC 
radio frequency (RF) Exposure rules. This 
equipment has very low levels of RF energy that is 
deemed to comply without maximum permissive 
exposure evaluation (MPE). But it is desirable that it 
should be installed and operated keeping the 
radiator at least 20 cm or more away from person’s 
body.
For the State of California, USA only
Perchlorate Material – special handling may apply, 
See
www.dtsc.ca.gov/hazardouswaste/perchlorate
Note on the lithium battery
Do not expose the battery to excessive heat such as 
direct sunlight, fire or the like.
Disclaimer regarding services offered by 
third parties
Services offered by third parties may be changed, 
suspended, or terminated without prior notice. 
Sony does not bear any responsibility in these sorts 
of situations.
Warning if your car’s ignition has no ACC 
position
Be sure to set the AUTO OFF function (page 19)
The unit will shut off completely and 
automatically in the set time after the unit is 
turned off, which prevents battery drain. If you 
do not set the AUTO OFF function, press and hold 
OFF until the display disappears each time you 
turn the ignition off.