Sony PCG-GR250P Manual

all connected devices. Disconnect the devices that are not in use. Check the 
connections for each device, and then restart your notebook.

❑

Check that the PC Card is installed properly.

❑

Check that the PC Card is compatible with Microsoft® Windows®.

❑

Use the Sony Notebook Setup utility to disable devices you are not currently 
using.

❑

If you are using two PC Cards, use the Sony Notebook Setup utility to 
disable the devices you are not currently using.

❑

Check that any necessary drivers were installed properly. See “Using Your 
Recovery CDs” for more information on installing the drivers.

Disconnect the i.LINK®

*

 cable from both computers and reconnect it.

Wait for the computers to respond. If neither computer responds after a few 
moments, restart both computers.

* i.LINK is a Sony trademark used to designate that a product contains an IEEE 1394 connec-

tion. The i.LINK connection may vary, depending on the software applications, operating 
system, and compatible i.LINK devices. All products with an i.LINK connector may not 
communicate with each other. Refer to the documentation that came with your compatible 
i.LINK device for information on operating conditions and proper connection. Before con-
necting compatible i.LINK PC peripherals to your system, such as a CD-RW or hard disk 
drive, confirm their operating system compatibility and required operating conditions.

✍

The computers may not recognize an i.LINK connection after returning from a power 
saving mode (Standby or Hibernate). If that happens, restart the computers to 
establish a connection.