D-Link DAS-3224_revB Manual De Usuario
6
Getting Started the DAS3series LCT
Figure 2-6
DAS3series LCT Install Wizard at Completed
Click ‘Finish’ to end the installation,
Uninstall LCT Software
Uninstall the DAS3series LCT software can be done through ‘Add or Remove Programs’ at Control
Panel.
Panel.
Execute LCT Software
DAS3series LCT can be accessed through Start Æ All Programs Æ LCT Æ DAS3series LCT.
To update the new version of DAS3series LCT, you have to uninstall the previous version before do
so.
so.
Configuring the DAS3series Community
This section describes the DAS3series IP-DSLAM network Ethernet IP and SNMP Host/Community
initial setting to engage with the DAS3series LCT. Task those setting by access to CLI Ex mode.
Access to CLI Ex mode via the Console Port can be done using a VT100-compatile terminal directly
connected.
To access the CLI Ex mode via a direct VT100-compatible terminal connection to the Console Port,
use the following procedure:
initial setting to engage with the DAS3series LCT. Task those setting by access to CLI Ex mode.
Access to CLI Ex mode via the Console Port can be done using a VT100-compatile terminal directly
connected.
To access the CLI Ex mode via a direct VT100-compatible terminal connection to the Console Port,
use the following procedure:
Table 2-1 DAS3series Console Management Setting
Parameter
Setting
Baud rate
9600
Data bits
8
Parity None
Start bits
Start bits
1
Stop bits
1
Flow control
None
DAS3series IP-DSLAM
System Configuration Guide