KitchenAid 30" Hood Liner Guía De Instalación

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Level

■

Drill

■

¹⁄₈" (3 mm) drill bit

■

Pencil

■

Pliers

■

Tape measure or ruler

■

Caulking gun and weatherproof caulking compound

■

Phillips screwdriver

■

Flat-blade screwdriver

■

Saber or keyhole saw

■

Vent clamps

■

Metal snips

■

6" (15.2 cm) round metal vent system 

■

1 wall or roof cap 

■

Recirculation Kit Part Number W10490330. See the 
“Assistance or Service” section to order.

Remove parts from packages. Check that all parts are included.

■

Damper

■

Hardware package. Includes:

Installation Instructions and Use and Care Guide

2 mounting brackets

6 spacers

10 - 4.5 x 13 mm wood screws

2 - 4.2 x 15 mm machine screws

4 - 3.5 x 9.5 mm flat-head sheet metal screws

8 - 4.2 x 19 mm sheet metal screws

2 - 3.5 x 9.5 mm sheet metal screws

1 - 30" x 12" (76.2 x 30.5 cm) face panel

2 metal grease filters

T10 TORX

®†

 adapter

8 - metal washers

8 - plastic washers

IMPORTANT: Observe all governing codes and ordinances.

Have a qualified technician install the range hood. It is the 
installer’s responsibility to comply with installation clearances 
specified on the model/serial rating plate. The model/serial rating 
plate is located inside the liner behind the filter on the left wall of 
the range hood.

Range hood location should be away from strong draft areas, 
such as windows, doors, and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given 
dimensions provide minimum clearance. Consult your cooktop/
range manufacturer installation instructions before making any 
cutouts.

This range hood is recommended for use with cooktops with a 
maximum total rating of 65,000 Btus or less.

Grounded electrical outlet is required. See “Electrical 
Requirements” section.

The range hood is factory set for vented installations through the 
roof or wall. For non-vented (recirculating) installations see “Non- 
Vented (recirculating) Installation Through the Soffit/Cabinet” in 
the “Prepare Location” section. Recirculation Kit Part Number 
W10490330 is available from your dealer or an authorized parts 
distributor.

All openings in ceiling and wall where range hood will be installed 
must be sealed.

The installation of this range hood must conform to the 
Manufactured Home Construction Safety Standards, Title 24 
CFR, Part 328 (formerly the Federal Standard for Mobile Home 
Construction and Safety, title 24, HUD, Part 280) or when such 
standard is not applicable, the standard for Manufactured Home 
Installation 1982 (Manufactured Home Sites, Communities and 
Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local 
codes.

†®TORX is a registered trademark of Saturn Fasteners, Inc.