Canon PowerShot G7 X Mark II Guía Del Usuario

171

 

●

To conserve battery power, you should normally choose [On] for 

[Auto Power Down] and [1 min.] or less for [Display Off].

 

●

The [Display Off] setting is applied even if you set [Auto Power 

Down] to [Off].

 

●

These power-saving functions are not available when you have 

Adjust screen brightness as follows.

 

z

Choose [Disp. Brightness] on the [ 2] 

tab, press the [ ] button, and then press 

the [ ][ ] buttons or turn the [ ] dial to 

adjust the brightness.

 

●

For maximum brightness, press and hold [ ] for at least one 
second when the shooting screen is displayed or when in single-
image display. (This will override the [Disp. Brightness] setting 
on the [ 2] tab.) To restore the original brightness, press and 
hold the [ ] button again for at least one second or restart the 
camera.

This function allows you to conserve battery power in Shooting mode. 

When the camera is not in use, the screen quickly darkens to reduce 

battery consumption.

 

z

Choose [Eco Mode] on the [ 2] tab, and 

then choose [On].

 

z

[

] is now shown on the shooting 

screen (= 197).

 

z

The screen darkens when the camera 

is not used for approximately two 

seconds; approximately ten seconds 

after darkening, the screen turns off. 

The camera turns off after approximately 

three minutes of inactivity.

 

z

To activate the screen and prepare for 

shooting when the screen is off but the 

lens is still out, press the shutter button 

halfway.

Adjust the timing of automatic camera and screen deactivation (Auto 

Power Down and Display Off, respectively) as needed (= 27).

 

z

Choose [Power Saving] on the [ 2] tab, 

and then press the [ ] button.

 

z

Choose an item, press the [ ] button, 

and then press the [ ][ ] buttons or turn 

the [ ] dial to configure the setting.