Canon DP-V3010 Manual

OSD Menu

Item

Setting Options (underline indicates factory default)

Area Marker

"Area Marker" is used to check a specific area using a rectangular box.

Note

• In the case of SDI signal, setting is disabled when "H Delay" or "V Delay" is "On".
• "Area Marker" is not displayed in the following cases:

When there is no signal, unsupported signal, or a channel with "Input Configuration" not set is
selected

When an enlarged image is displayed

During the execution of "Playback File" under "Screen Capture"

When "H Delay"/"V Delay" is "On"

When a "Test Pattern" is displayed

When "Peaking 1" or "Peaking 2" is selected

Enable

Switches the area marker On, Off.
On, Off

H Position

Sets the start position (x-coordinate) to draw the rectangle (in increments of 2).
0 to 4086 (240)

V Position

Sets the start position (y-coordinate) to draw the rectangle (in increments of 2).
0 to 2550 (120)

Width (dot)

Sets the width of the rectangle (in increments of 2).
10 to 4096 (240)

Height (dot)

Sets the height of the rectangle (in increments of 2).
10 to 2560 (120)

Mask

Switches the mask color (in the marker).
Black, Half, Off

Note

• Because the Wave Form Monitor, Vector Scope and Time Code appear under the Mask, a

part of them is hidden by the Mask.

Line

Turns On/Off the outlines of the rectangular box.
On, Off

Line Width

Sets the width of the area marker line.
Thick, Normal, Thin

Line Color

Sets the color of the area marker line.
White, Red, Green, Blue, Yellow, Cyan, Magenta

Line
Brightness

Sets the brightness of the area marker line.
High, Low