Canon DP-V3010 Manual
59
OSD Menu
Item
Setting Options (underline indicates factory default)
Area Marker
"Area Marker" is used to check a specific area using a rectangular box.
Note
• In the case of SDI signal, setting is disabled when "H Delay" or "V Delay" is "On".
• "Area Marker" is not displayed in the following cases:
• "Area Marker" is not displayed in the following cases:
-
When there is no signal, unsupported signal, or a channel with "Input Configuration" not set is
selected
selected
-
When an enlarged image is displayed
-
During the execution of "Playback File" under "Screen Capture"
-
When "H Delay"/"V Delay" is "On"
-
When a "Test Pattern" is displayed
-
When "Peaking 1" or "Peaking 2" is selected
Enable
Switches the area marker On, Off.
On, Off
On, Off
H Position
Sets the start position (x-coordinate) to draw the rectangle (in increments of 2).
0 to 4086 (240)
0 to 4086 (240)
V Position
Sets the start position (y-coordinate) to draw the rectangle (in increments of 2).
0 to 2550 (120)
0 to 2550 (120)
Width (dot)
Sets the width of the rectangle (in increments of 2).
10 to 4096 (240)
10 to 4096 (240)
Height (dot)
Sets the height of the rectangle (in increments of 2).
10 to 2560 (120)
10 to 2560 (120)
Mask
Switches the mask color (in the marker).
Black, Half, Off
Black, Half, Off
Note
• Because the Wave Form Monitor, Vector Scope and Time Code appear under the Mask, a
part of them is hidden by the Mask.
Line
Turns On/Off the outlines of the rectangular box.
On, Off
On, Off
Line Width
Sets the width of the area marker line.
Thick, Normal, Thin
Thick, Normal, Thin
Line Color
Sets the color of the area marker line.
White, Red, Green, Blue, Yellow, Cyan, Magenta
White, Red, Green, Blue, Yellow, Cyan, Magenta
Line
Brightness
Brightness
Sets the brightness of the area marker line.
High, Low
High, Low