ASUS H61-PLUS Manual De Usuario

Descargar
Página de 84
2-20
Chapter 2: Getting started
Active Memory Threshold [x]
This item appears only when you set the Active Page Threshold Support to 
[Enabled] and allows you to set the Active Memory Threshold. When the partition size 
is larger than the Active Page Threshold size, the system will try to support the Intel(R) 
Rapid Start Technology. When the item is set to zero, the system automatically checks 
whether the partition size is enough at S3 entry. Key in the desired value using the 
numeric keypad.
Intel(R) Smart Connect Technology
ISCT Configuration [Disabled]
Allows you to enable or disable the ISCT configuration. Configuration options: [Enabled] 
[Disabled]
2.5.3 
SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The 
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA 
port.
SATA Mode Selection [AHCI]
Allows you to set the SATA configuration.
[IDE] 
Set to [IDE] when you want to use the Serial ATA hard disk drives as 
Parallel ATA physical storage devices.
[AHCI] 
Set to [AHCI] when you want the SATA hard disk drives to use the AHCI 
(Advanced Host Controller Interface). The AHCI allows the onboard storage 
driver to enable advanced Serial ATA features that increases storage 
performance on random workloads by allowing the drive to internally 
optimize the order of commands.
Due to H61 Chipset limitation, AHCI Mode only works on Windows
®
 Vista / Windows
®
 7. 
Please use IDE Mode on Windows
®
 XP.
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When 
read/write of your hard disk errors occur, this feature allows the hard disk to report warning 
messages during the POST. This item appears only when you set the previous item to [IDE] 
or [AHCI]. Configuration options: [Enabled] [Disabled] 
Hot Plug [Disabled]
This item only appears when you set the SATA Mode Selection item to [AHCI] and allows you 
to enable or disable the hot-plug support for each SATA port. Configuration options: [Enabled] 
[Disabled]
2.5.4 
System Agent Configuration
Memory Remap Feature [Enabled]
[Enabled] 
Allow you to enable remapping the memory above 4GB.
[Disabled] 
Disables this function.