ASUS ESC4000 Guía De Instalación Rápida

Chapter 2: Components

2-8

The ASUS PIKE RAID module allows users to create RAID function from SAS hard 

disk drives connected to the SAS connectors on the motherboard.

90-C1SE10-00UAY20Z

PIKE 2008 8-port SAS 6G RAID Kit (RAID 0, 1, 1E)

90-C1SE15-00UAY00Z

PIKE 2008/IMR 8-port SAS 6G RAID Kit (RAID 0, 1, 5)

90-C1SEF0-00UAY00Z

PIKE 2008 8-port SAS 6G RAID Kit (RAID 0, 1, 5,6,10, 50, 60)

1.  Firmly hold the riser card bracket, and then pull it up to detach it from the PCI 

Express x16 slot on the motherboard.

2.  Align and insert the golden fingers of the PIKE SAS RAID card into the card 

slot on the PIKE raiser card. Ensure the card is completely seated on the slot. 

3.  Remove the SATA/SAS cables from the onboard SATA connectors and 

connect the SATA/SAS cables to the SAS1–8 connectors on the PIKE riser 

card.`

4.  Connect the SGPIO2 cable (with a green label) to the SGPIO1 connector and 

the SGPIO3 cable (without a label) to the SGPIO2 connector on the PIKE 

riser card.

5.  Install the i Button*.
 

* PIKE 1078 module won’t function if the i Button is not installed.

6.  Align the riser card bracket to the PCI Express x16 slot on the motherboard 

and press the riser card bracket until the golden fingers completely fit the slot 

and the bracket aligns with the rear panel.