Canon VB-R11 Manual
S
ett
ing Page
ing Page
4
119
Separate access control from IPv4 and IPv6 addresses can be set.
Note
If the same address is duplicated, the policy for the address that appears highest on the list will be applied.
IPv4 Host Access Restrictions
Specify the hosts from which IPv4 access is permitted and restricted.
[Apply Host Access Restrictions]
Select whether to use IPv4 host access restrictions.
Select whether to use IPv4 host access restrictions.
[Default Policy]
Select whether to allow or block access from IPv4 addresses that have not been specified in [Network Address / Subnet].
Select whether to allow or block access from IPv4 addresses that have not been specified in [Network Address / Subnet].
[Network Address / Subnet]
Enter IPv4 addresses into the list and select [Yes] or [No] for access for each address.
Enter IPv4 addresses into the list and select [Yes] or [No] for access for each address.
You can specify the subnet to set access restrictions by network or host.
If set to [No], access to all ports is blocked.
Set Access Restrictions
[Security] > [Host Access Restrictions]
[Security] > [Host Access Restrictions]
Important
• To prohibit access via a proxy server in HTTP connection, a proxy server address must be set.
• If host access restriction is set mistakenly, access to the Setting Pages themselves may be prohibited, in which case restoring the
factory default settings will become the only means for recovery.