Canon VB-R11 Manual
S
ett
ing Page
ing Page
4
89
Settings for HTTP server, SNMP server, FTP server usage or WS-Security time checks.
HTTP Server
Set the authentication method and HTTP port number.
[Authentication Method]
Select an authentication method for use by the HTTP server.
Select an authentication method for use by the HTTP server.
[HTTP Port]
Enter an HTTP port number.
Enter an HTTP port number.
Normally use [80] (factory default setting).
[HTTPS Port]
Enter an HTTPS port number.
Normally use [443] (factory default setting).
SNMP Server
Configure the necessary settings to use SNMP.
Note
• The camera information referenced from the SNMP manager is read-only.
• Use an SNMP Manager that supports SNMP MIB2 (supporting RFC1213).
• Supports SNMP protocol versions v1 and v2c (v3 unsupported).
[SNMP]
Select this to enable or disable SNMP.
Select this to enable or disable SNMP.
When using SNMP, the camera information can be referenced by the SNMP Manager.
[Community Name]
Enter a community name for SNMP.
Enter a community name for SNMP.
HTTP, SNMP and FTP Server Settings
[Server] > [Server Settings]
[Server] > [Server Settings]
Important
If the setting of [HTTP Port] or [HTTPS Port] is changed and the camera may become inaccessible from the active web browser, a
confirmation dialog box will appear. Click [OK] to apply the new setting.
If you reboot the camera and cannot connect to the camera from the web browser, any available URI for connecting to the camera will be
displayed in a message.
If you cannot connect to the camera through the displayed URI, contact your system administrator.
confirmation dialog box will appear. Click [OK] to apply the new setting.
If you reboot the camera and cannot connect to the camera from the web browser, any available URI for connecting to the camera will be
displayed in a message.
If you cannot connect to the camera through the displayed URI, contact your system administrator.